Jump to content
www.BoXa.net

Mattman42

Members
  • Content Count

    2,015
  • Joined

  • Last visited

  • Days Won

    15

Everything posted by Mattman42

  1. just checked on mine and don't appear to have those (987.2) - but there is some elastic straps either side which appear to tension in the inner head lining - could that be yours too?
  2. Yep, my wife did this to mine, really simple fix with replacement plastic ends from eBay - @chanlon1 I posted my fix and pics here; http://www.BoXa.net/forum/topic/78216-987-roof-broken-where-to-buy-parts/
  3. Not sure if this will be of any help, but replaced the drivers side rear mud flap today on my 987.2 This was my problem, the flap was cracked and filling up with dirt and road debris There are 5 Torx screws holding it in position, and ideally it would be a lot easier to do this with the rear wheel removed, but it can be done withthe right tools. Two fixings in the inner wheel well; Two further fixings underneath, one to the front and one located in the well and a final one located further under the car Of course I didn’t have the right tools, the screwdriver handles I had were too long, therefore a Torx bit and mole grips were required to be able to undo them Old one removed, you can see the dirt that builds up behind the part; i purchased rhe new mud flap from Design9 off of eBay, approx £35 With a close up of the part number if needed; once removed, I cleared out all the dirt and debris from around the inner arch. Before fitting the new one, remember to swap the clips from the old one otherwise the fixings have nothing to bite into. The hardest part of refitting is to get the clip at the top to fit behind the wheel arch lip. Took a bit of jiggling, but once that’s in place, everything else seems to slide into place easily. All fitted and fixed; whole job took about 30mins start to finish, probably would have been quicker if I had the right tools or removed the wheel first....
  4. #pokeypokepoke - if i suggested Mrs Matt drive a C1 or similar she would park it firmly where the sun don't shine. Even my 17 year old son said no to a C1 - you really need to give her a car befitting of her superhero status @rowbos
  5. Are you sure?, perhaps we need @rowbos wife to confirmif a C1 lives up to her standards.....
  6. Mattman42

    Doors frozen

    @JohnK swears by this stuff too - its the only way he can get out of the gimp suit after a long weekend
  7. was the discount greater than the cost of the day though?
  8. Renewal time - Priviledge are current insurers want £740 - 2 drivers, 9 years NCD, 1 accident each (neither at fault) - best renewal so far is about £550 - trying NFU and Adrian Flux. More Than wanted 1550!!! Lowest quote was £445 with a black box - errr no! ????
  9. Lol - not seen one of those for a while I have PCM3.0 but don't have the aux ports in the console, just the 12V supply
  10. Thread resurrection! if you have PCM 3.0 fitted without the aux ports, can you DIY retrofit a usb or does it need the dealer? Is there a connector on the back you can just plug into or does it need software updates etc?
×
×
  • Create New...