Jump to content

Carrying a spare wheel - 987 S


Berty987

Recommended Posts

I mentioned a few years ago, that the 996/ 986 17 inch space saver will fit on a 987 / 987S. Since I had to change the rear tyres at the weekend , I took the opportunity to photograph the stowage location for the removed wheel on the rear trunk / boot. Using some simple bungee chords and a rubber mat ( all of which can be stored in the spare wheel cover ) the removed rear 265/35/19 wheel can be carried on top of the rear luggage compartment to a convenient point to have the puncture repaired or tyre replaced. The only addition I would make to the photographed procedure would be to raise the rear spoiler to act as an additional stop to ensure the wheel is supported a little more.

The procedure allows for a swift roadside repair without compromising the passenger or luggage already in the car. Carrying a spare wheel will also allow for onward travel should the tyre glue be unable to repair the tyre as in the case of a ruptured sidewall or significant split (ie hitting a pot hole).

The first step is to change the wheel , If you buy a used wheel with the foam insert containing tools you have everything you need including jack and wheel spanner. The 986/997 17" space saver is a 105 section , so can fit in the front luggage compartment and still allow space for a suitcase.

IMG_8881.jpg

The next step is to fit the bungee chords to the slots on the underside of the rear luggage/ boot cover.

IMG_9340.jpg

The more chords you use the more secure the load in transit

IMG_9344.jpg

Next you need to ensure all the ends are on top of the cover before closing

IMG_9343.jpg

Place a rubber mat over the top of the cover to protect the wheel and paintwork. It also prevents slipping. I guess you could use the interior car mats for this if nothing else was available.

IMG_9346.jpg

Gently place the wheel on top of the boot cover , remember the rear cover is aluminium so can dent easilly if you drop the wheel on it.

IMG_9349.jpg

And ready for onward travel , Ideally I would raise the spoiler too , to act as additional support.

IMG_9350.jpg

Edited by Berty987
  • Like 1
Link to comment
Share on other sites

  • 2 years later...

Genius! Hat off to you Sir! I'm out to get some bungee cords tomorrow morning.

I would add to this that the clamshell cover dents incredibly easily. So be careful when lifting the wheel on top of the boot lid.

Edited by teknow
  • Like 1
Link to comment
Share on other sites

Genius! Hat off to you Sir! I'm out to get some bungee cords tomorrow morning.

I would add to this that the clamshell cover dents incredibly easily. So be careful when lifting the wheel on top of the boot lid.

If fitting a 986/996 space saver to a 987/997 you also need to de activate the PSM as the wheel diameter is smaller than standard and will trigger PSM and ABS faults on the dash. The faults will clear once the PSM is de activated after the car has stopped and engine has been re started or correct wheel fitted. The car will also sit slightly lower on the corner where the 986 space saver is fitted. Though the 986 space saver isnt designed for the 987 it will get you home in an emergency or to the local tyre shop if travelling abroad. I suggest getting both the 17" skinny space saver (105 90 17) as well as the jack and tools from a 986 rather than the 987 165 65 17 space saver as its both lighter and takes up less space.

I believe that the 986 wheels will fit in the front trunk of a 986 if the tyre is flat , someone with a 986 may be able to confirm.

Link to comment
Share on other sites

  • 5 years later...
  • Araf pinned this topic
  • 8 months later...
  • 1 year later...
On 11/1/2017 at 10:40 AM, maybe said:

I thought spacesaver wheels had to be fiitted on the front axle? So if you had a rear puncture,  the front had to go on the back, and the spacesaver on the front.

May be imagining this?

This always used to be the case on the old 911s    

Personally I would do this too I would not fancy driving with the space saver on the rear 😜

Link to comment
Share on other sites

  • 5 months later...

Hi very useful advice.

Can you advise where you bought the rubber mat from ?

What length were the bungee  chords they look like heavy duty ones ? Where were this purchased from ? 

Are you able to fit the space saver on the rear axle as suggested and shown in the photos ?

Thanks 

Graham 

 

Edited by Grah60
Wrong spelling
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...