Cooks

Removed alternator ready for a replacement. Was making an awful noise and not charging the battery. I must say lots of swearing and bashed knuckles. That sucker was in there good and proper! 

Rear brake pads. Pin was very hard to remove. Haven't been done in a long time is my guess! 

On 6/5/2018 at 9:06 PM, Saxosim said:

@Cooks you can remove the plinth and just mount the number plate using the holes left from the plinth on the bumper through the plate.  I just measured it all out and then had a standard height but reduced width plate made up.  I drilled the holes towards the top edge as you can see

 

That's great! Will get that sorted this weekend. 

Nick - did you remove the number plate mount on the front? I have a smaller 5 digit plate and want to install on the bumper without the mount. 

Did you just use the holes for the player holder screws?