daz05 Posted August 13, 2019 Report Share Posted August 13, 2019 Guys, have any of you had this issue. Mine is making a racket on one side, really annoying as we were on a road trip at the time and ive had to cut it short. Any help appreciated, opc job or local indy? Link to comment Share on other sites More sharing options...
daz05 Posted August 13, 2019 Author Report Share Posted August 13, 2019 Got under the car for a look, there doesnt appear to be a nut on the flange where the back box connects and it's now loose. It's on the side the opc changed the back box previously. Link to comment Share on other sites More sharing options...
981Ad Posted August 14, 2019 Report Share Posted August 14, 2019 Sounds like it corroded off. Common problem due to the design! Link to comment Share on other sites More sharing options...
Greenman Posted August 14, 2019 Report Share Posted August 14, 2019 If it’s under warranty then I’d get the OPC that did the back box to do it and it should be covered. Otherwise any local garage or exhaust place, you may need a new gasket (only about £3) and might need to disconnect the other bolt to refit properly but shouldn’t cost more than £20-30 at a garage. Link to comment Share on other sites More sharing options...
daz05 Posted August 14, 2019 Author Report Share Posted August 14, 2019 3 hours ago, Greenman said: If it’s under warranty then I’d get the OPC that did the back box to do it and it should be covered. Otherwise any local garage or exhaust place, you may need a new gasket (only about £3) and might need to disconnect the other bolt to refit properly but shouldn’t cost more than £20-30 at a garage. Thanks, i had a go myself but what was left of the studs had attached themselves to the flange and just wouldn't budge. For the cost i decided just to book it into an indy. Hopefully collect tomorrow. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.