marts500 Posted September 15, 2019 Report Share Posted September 15, 2019 Fitted a new AOS and long vent pipe today on my 2.7 '07 987.But after getting ready to fix back down the throttle body T piece..noticed a loose 2 pin plug that comes from underneath the left bank intake.Can't seem to find it goes....? Any ideas Link to comment Share on other sites More sharing options...
DaveEFI Posted September 16, 2019 Report Share Posted September 16, 2019 That is a Junior Timer connector, and commonly used for injectors and sensors. Link to comment Share on other sites More sharing options...
Richard Hamilton Posted September 16, 2019 Report Share Posted September 16, 2019 What are the wire colours? Difficult to make them out from the photo. Link to comment Share on other sites More sharing options...
marts500 Posted September 16, 2019 Author Report Share Posted September 16, 2019 I think red/purple & pink.I emailed Russ at Revolution and he seems to think its the connector for the evap valve that lives under the L/H intake.Hope i can get it reconnected.Its a bit tight in there.Think i need a stick mirror. Link to comment Share on other sites More sharing options...
Richard Hamilton Posted September 16, 2019 Report Share Posted September 16, 2019 The tank venting valve (EVAP) has a Red/Blue and a Violet wire, so it sounds like that might be the one. Good luck! Link to comment Share on other sites More sharing options...
marts500 Posted September 16, 2019 Author Report Share Posted September 16, 2019 Fingers crossed....the long vent pipe was a nightmare to fit.I had to warm it up and unshape / reshape it to get it threaded through underneath the intake. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.