Gutley Posted November 4, 2017 Report Share Posted November 4, 2017 Whilst my front bumper was off I noticed that the cable for my emergency Bonnet release seems to have embedded itself into the fixing for the front headlamp washer pipe: I'm pretty sure that isn't where its supposed to be, and it looks like its been slowly cutting its way through that support for a long time. Assuming this isn't the right place for it, where should it be routed? Link to comment Share on other sites More sharing options...
Greenman Posted November 5, 2017 Report Share Posted November 5, 2017 I don’t know (I don’t have a 986) but if it is actually cutting into that support it must have had somewhat more use than designed for!. I wouldn’t be suprised if that routing is normal as it wouldn’t normally be under much tension and is for very occasional use Link to comment Share on other sites More sharing options...
Gutley Posted November 5, 2017 Author Report Share Posted November 5, 2017 In the end I tucked it below the fixing. Where it was it was impossible to actually pull the cable anyway as it was so well clamped where it was it wouldn't budge. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.