stupidget Posted March 7, 2021 Report Share Posted March 7, 2021 I think the springs have gone in the bottom part of my drivers side seat as it seems to sink lower than the passenger side one. Does anybody know if it's possible to fix this? Link to comment Share on other sites More sharing options...
Shazbot Posted March 11, 2021 Report Share Posted March 11, 2021 They're not really springs more like a plastic web. Not sure if it's available separately, sorted mine with some large cable ties to re-join the 'web' and remove the sag. Link to comment Share on other sites More sharing options...
mvw Posted March 12, 2021 Report Share Posted March 12, 2021 This is what you need https://www.rosepassion.com/en/99652150702-p71913-mat-99652150701-P71913 I repaired mine with some upholstery thread before I knew you could pick them up for for a reasonable price. Link to comment Share on other sites More sharing options...
SimonT001 Posted March 12, 2021 Report Share Posted March 12, 2021 I think mine is very much in need of this although I haven't sat in another for comparison. Is it an easy job? Link to comment Share on other sites More sharing options...
stupidget Posted March 12, 2021 Author Report Share Posted March 12, 2021 Thanks for the feed back on what needs to be done. I've found this on the 986forum site: https://tinyurl.com/4ytw9a25 is this similar to what you did @Shazbot@mvw Link to comment Share on other sites More sharing options...
mvw Posted March 13, 2021 Report Share Posted March 13, 2021 Similar, I had my seat base out as I was fitting a heated element. While I had access I put some big stitches in across the split in the part hessian/rubber band shown in that thread. I have an upholstery needle and thread I used to repair my roof a while back. I fully expect my fix to fail at some point, at which time I’ll buy a new part. It looks straightforward to fit Link to comment Share on other sites More sharing options...
.thumb.jpg.7d4f09b4adc28885515686fe1fad6858.jpg)
Recommended Posts
Archived
This topic is now archived and is closed to further replies.