Cheddar Bob Posted September 20, 2020 Report Share Posted September 20, 2020 Thanks @Bluepork03 for the tip that. I'm swapping these two parts, any advice for hidden issues Link to comment Share on other sites More sharing options...
golfprorich Posted September 20, 2020 Report Share Posted September 20, 2020 Get a helping hand for the bonnet! Bumper is an easy one man job but even easier with two 👍🏻👍🏻 Technically its very simple with just a few fixings here and there Link to comment Share on other sites More sharing options...
Bluepork03 Posted September 20, 2020 Report Share Posted September 20, 2020 ^^^This Also if the bumper hasn't been off in a while you might want to give all the fixings underneath a squirt of penetrating oil well in advance. Link to comment Share on other sites More sharing options...
½cwt Posted September 20, 2020 Report Share Posted September 20, 2020 59 minutes ago, Bluepork03 said: ^^^This Also if the bumper hasn't been off in a while you might want to give all the fixings underneath a squirt of penetrating oil well in advance. Also worth swapping all the screws to stainless to future proof against corrosion, or at least put grease in the speed nuts to coat the thread when you re fit them. I also silicone sprayed the plastic grommets in the wheel arches and the leading edge of the under tray (loosening this makes it easier to line everything up so all the tabs go into the slots when you refit the bumper), makes them much easier to re fit and to pull the centres out next time you take it off. Link to comment Share on other sites More sharing options...
Cheddar Bob Posted September 22, 2020 Author Report Share Posted September 22, 2020 cheers all. Link to comment Share on other sites More sharing options...
Cheddar Bob Posted September 27, 2020 Author Report Share Posted September 27, 2020 all done photos here : Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.