Jump to content

How To: Bring your Dash Speakers up to spec


cj225

Recommended Posts

2 hours ago, jimk04 said:

Are 986 bose dash speakers still this same garbage?

I doubt it.  The 'garbage' is 4 ohm and Bose use 2 ohm impedance - so it would have to be specially made garbage. ;) 

Link to comment
Share on other sites

  • 3 months later...

I'm doing the conversion tomorrow with the same speakers as OP.

The new speakers have a positive and negative terminal but the original speaker doesn't have any indication - can I connect the new speaker terminals to either side of the retained connector block?

Link to comment
Share on other sites

On 4/12/2017 at 8:21 PM, drumsterphil said:

I'm doing the conversion tomorrow with the same speakers as OP.

The new speakers have a positive and negative terminal but the original speaker doesn't have any indication - can I connect the new speaker terminals to either side of the retained connector block?

Pretty sure there is a + sign on the positive terminal of the plastic socket. It's not that obvious but it is there if you look closely. 

Link to comment
Share on other sites

10 minutes ago, Madlil said:

Pretty sure there is a + sign on the positive terminal of the plastic socket. It's not that obvious but it is there if you look closely. 

Luckily it's easier than that thanks to google - left hand speaker and the yellow/brown plug cable is negative; right hand is red/brown.

Link to comment
Share on other sites

  • 2 weeks later...

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...